|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
If you need to readjust the pickup height � If the pickup height needs to be re-adjusted, remove the strings and carefully pry the pickup from the guitar by sliding a thin, flat object (e.g. a small knife blade) under the sixth-string end of the pickup � between the pickup and top spacer � and gently lifting the pickup away from the spacer.
I Installation Procedure � Screw
Screw installation has several advantages over tape installation: screw installation is more secure, the height of the pickup can be more precisely adjusted, and pickup height can be easily readjusted as required without having to remove and reattach double-sided tape.
I NOTES � Screw installation requires at least a 13 millimeter (1/2�) space between the guitar top and strings.
1. Mark the optimum position for installation.
The pickup should be located between the bridge pickup and bridge (see �NOTES� below). The cable end of the pickup should be oriented toward the sixth string (low E). One pair of the pickup�s magnetic yokes should be under each string. String spacing varies somewhat on different guitars, and the pickup will function properly as long as each string passes over part of the corresponding yokes (not necessarily the exact center).
The double-sided tape can then be �rolled� off the bottom of the pickup as shown in the illustration.
Bridge pickup
Bridge
Readjust the height as required by adding or removing spacers: � To add a new spacer in order to raise the pickup, remove any used double-sided tape from the existing spacer, then attach the new spacer to the top of the existing spacer after removing its backing. � When removing a spacer to lower the pickup, be sure to remove both the spacer and its backing tape.
OK OK NG
Pickup
No more than 20 millimeters (3/4")
Finally, attach fresh double-sided tape to the bottom of the pickup, remove the backing, carefully attach the pickup to the uppermost spacer, then re-string and tune the guitar.
String
Pickup�s magnetic yokes
Installation
11
|
|
|
> |
|
